Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
10.1. Features of a design
10.2. Assembly blocks
10.3. Rechargeable battery
10.4. Generator
10.5. Starter
10.6. Switch (lock) of ignition
10.7. Control system of the engine
10.8. Lighting, light and sound alarm system
10.9. Replacement of a motor-reducer of a screen wiper of a wind window
10:10. Removal and installation of a washer of glass of a wind window
10:11. Removal and installation of the electric motor of the main fan of a radiator of the cooling system of the engine
10:12. Removal and installation of the electric motor of the additional fan of a radiator of the cooling system of the engine
10:13. Back window glass electrical heating
10:14. Removal and installation of the boss of the lighter
10:15. Combination of devices
10:16. Dashboard switches
10:17. Replacement of control units of electrowindow regulators
10:18. Automobile audio system
10:19. Replacement of sensors and switches
10.19.1. Replacement of the sensor of an alarm lamp of emergency pressure drop of oil
10.19.2. Check and replacement of the sensor of the index of temperature of cooling liquid
10.19.3. Check and replacement of the sensor of the index of level of fuel
10.19.4. Check and replacement of the switch of light of a backing
10.19.5. Replacement of the switch of a stoplight
10.19.6. Replacement of the switch of an alarm lamp of turning on of the parking brake
10.19.7. Replacement of switches of a plafond of illumination of salon
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








10-19-3-proverka-i-zamena-datchika-ukazatelya-urovnya-topliva.html

10.19.3. Check and replacement of the sensor of the index of level of fuel

The sensor of the index of level of fuel is a part of the fuel module and is not subject to replacement in garage conditions therefore in case of a sensor exit out of operation it is necessary to replace the fuel module assembled.
For check of the sensor you will need an autotester.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove the fuel module (see. "Replacement of the fuel pump").
3. Connect a tester in the ohmmeter mode to conclusions of a block of the fuel module.
4. Measure and remember value of resistance of the sensor in a starting position.
5. Lift the lever with a float in extreme situation — resistance has to decrease almost to zero. If resistance does not change or remains too big, then the sensor is faulty and it is necessary to replace the fuel module.
6. Establish details as it should be, the return to removal.

"previous page
10.19.2. Check and replacement of the sensor of the index of temperature of cooling liquid
following page"
10.19.4. Check and replacement of the switch of light of a backing