Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
10.1. Features of a design
10.2. Assembly blocks
10.3. Rechargeable battery
10.4. Generator
10.4.1. Features of a design
10.4.2. Possible malfunctions of the generator, their reason and ways of elimination
10.4.3. Removal and installation of the generator
10.4.4. Replacement of a pulley of the generator
10.4.5. Repair of the generator
10.5. Starter
10.6. Switch (lock) of ignition
10.7. Control system of the engine
10.8. Lighting, light and sound alarm system
10.9. Replacement of a motor-reducer of a screen wiper of a wind window
10:10. Removal and installation of a washer of glass of a wind window
10:11. Removal and installation of the electric motor of the main fan of a radiator of the cooling system of the engine
10:12. Removal and installation of the electric motor of the additional fan of a radiator of the cooling system of the engine
10:13. Back window glass electrical heating
10:14. Removal and installation of the boss of the lighter
10:15. Combination of devices
10:16. Dashboard switches
10:17. Replacement of control units of electrowindow regulators
10:18. Automobile audio system
10:19. Replacement of sensors and switches
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








10-4-3-snyatie-i-ustanovka-generatora.html

10.4.3. Removal and installation of the generator

You will need two keys "on 12".
1. Disconnect a wire from the minus plug of the rechargeable battery.

NOTE
The belt of the drive of the generator and pump of the hydraulic booster of steering does not need to be taken off from the car, it is enough to remove of it from a generator pulley. At the same time it is not necessary to take off a conditioner compressor drive belt.

3. Finally turn out a bolt of fastening of the generator to a tension level.
4. Wring out a clamp and disconnect a block of a plait of wires from the generator.
5. Turn off a nut of fastening of a tip of a wire …
6. … also disconnect a wire from a generator conclusion.
7. Turn off nuts 2, holding bolts 1 from a provorachivaniye, and take bolts.
    
NOTE
The photo of fastening of the generator is made from below the car for descriptive reasons. Turn off nuts and take bolts from above from podkapotny space.

8. Take the generator from podkapotny space.
9. Install the generator as it should be, the return to removal.
10. Establish into place a belt of the drive of the generator and adjust its tension (see. "Check and adjustment of a tension of a belt of the drive of the generator and pump of the hydraulic booster of steering").

"previous page
10.4.2. Possible malfunctions of the generator, their reason and ways of elimination
following page"
10.4.4. Replacement of a pulley of the generator