Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
10.1. Features of a design
10.2. Assembly blocks
10.3. Rechargeable battery
10.4. Generator
10.5. Starter
10.6. Switch (lock) of ignition
10.7. Control system of the engine
10.8. Lighting, light and sound alarm system
10.9. Replacement of a motor-reducer of a screen wiper of a wind window
10:10. Removal and installation of a washer of glass of a wind window
10:11. Removal and installation of the electric motor of the main fan of a radiator of the cooling system of the engine
10:12. Removal and installation of the electric motor of the additional fan of a radiator of the cooling system of the engine
10:13. Back window glass electrical heating
10:14. Removal and installation of the boss of the lighter
10:15. Combination of devices
10:16. Dashboard switches
10:17. Replacement of control units of electrowindow regulators
10:18. Automobile audio system
10:19. Replacement of sensors and switches
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








10-9-zamena-motoreduktora-stekloochistitelya-vetrovogo-okna.html

10.9. Replacement of a motor-reducer of a screen wiper of a wind window

It will be required to you: a face head "on 10", the extender, the screw-driver with a flat edge.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove the left half of a lattice of a box of airinflow (see. "Removal and installation of a lattice of a box of airinflow").
3. Using the screw-driver as the lever, disconnect draft of the drive of a screen wiper from a motor-reducer crank.
4. Squeeze a clamp and disconnect a block of a plait of wires from a motor-reducer.
5. Turn out four bolts of fastening …
6. … also remove a motor-reducer, having shifted it forward to take a crank from an opening in a body.
7. If necessary turn off a nut of fastening of a crank and remove a crank, having marked or having remembered its arrangement on a motor-reducer shaft for correct installation.
8. Establish details as it should be, the return to removal.

"previous page
10.8.12. Removal, installation and adjustment of a sound signal
following page"
10:10. Removal and installation of a washer of glass of a wind window