Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and flaps
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box of airinflow
11.8. Cowl
11.9. Doors
11:10. Trunk lid
11:11. Cover of the hatch of a bulk pipe of the fuel tank
11:12. Seats
11:13. Removal and installation of facing of a tunnel of a floor
11:14. System of passive safety (SRS)
11:15. Rear-view mirrors
11:16. Dashboard
11:17. Heater and conditioner
11:18. Fittings of salon
11:19. Removal and installation of facings of salon
11:20. Removal and installation of facings of a luggage carrier
11:21. Screen wiper of a wind window
11:22. Replacement of a motionless glazing of a body
11:23. Removal and installation of the shelf of fastening of the rechargeable battery
11:24. Care of a body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








11-13-snyatie-i-ustanovka-oblicovki-tonnelya-pola.html

11:13. Removal and installation of facing of a tunnel of a floor

Facing of a tunnel of a floor consists of two parts: forward and back.
You will need the screw-driver with a crosswise edge.
1. Turn out two screws behind a back part of facing at the left …
2. … and on the right.

NOTE
The seat of the driver is removed for descriptive reasons. For receiving access to fastenings of facing it is not required to remove a seat.

3. Lift the lever of the parking brake up, shift a little back part of facing back, bringing its clamps out of gearing with a forward part …
4. … also remove it, having moved on the lever of the parking brake up and forward.

    
NOTE
For removal of a forward part of facing of a tunnel of a floor it is optional to remove a back part, it is enough to turn out screws of its fastening and to shift a little back.

5. Take from a forward part of facing of a tunnel of a floor a control lever cover frame the transmission, overcoming effort of its clamps.
6. Through a window for installation of a cover of a control lever the transmission separate a block of a plait of wires of the lighter.
7. Turn out one screw of fastening behind a forward part of facing …
8. … and two screws ahead.

    
NOTE
The second screw of fastening of a forward part of facing of a tunnel of a floor is symmetrized rather longitudinal axis of the car.

9. Develop a control lever cover frame the transmission so that it passed in an opening of a forward part of facing of a tunnel of a floor, and remove a forward part of facing.
10. Establish parts of facing of a tunnel of a floor as it should be, the return to removal.

"previous page
11.12.3. Removal and installation of a back seat
following page"
11:14. System of passive safety (SRS)