Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and flaps
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box of airinflow
11.8. Cowl
11.9. Doors
11:10. Trunk lid
11:11. Cover of the hatch of a bulk pipe of the fuel tank
11:12. Seats
11:13. Removal and installation of facing of a tunnel of a floor
11:14. System of passive safety (SRS)
11.14.1. Features of a design
11.14.2. Removal and installation of a safety cushion of the driver
11.14.3. Replacement of a forward seat belt
11.14.4. Replacement of a back seat belt
11.14.5. Removal and installation of an electronic control unit additional system of passive safety
11:15. Rear-view mirrors
11:16. Dashboard
11:17. Heater and conditioner
11:18. Fittings of salon
11:19. Removal and installation of facings of salon
11:20. Removal and installation of facings of a luggage carrier
11:21. Screen wiper of a wind window
11:22. Replacement of a motionless glazing of a body
11:23. Removal and installation of the shelf of fastening of the rechargeable battery
11:24. Care of a body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








11-14-5-snyatie-i-ustanovka-ehlektronnogo-bloka-upravleniya-dopolnitelnojj-sistemojj-passivnojj-bezopasnosti.html

11.14.5. Removal and installation of an electronic control unit additional system of passive safety

It will be required to you: all tools necessary for removal of facing of a tunnel of a floor, and TORX T30 key.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove facing of a tunnel of a floor (see. "Removal and installation of facing of a tunnel of a floor").
3. Cast away a clamp of a block of a plait of wires of an electronic control unit …
4. … also disconnect a block from the block.
5. Turn out three bolts of fastening of the control unit to the body basis …
6. … also remove the block.

NOTE
Pay attention to marking of the control unit, for replacement buy the block with the same marking.

7. Establish an electronic control unit by system of passive safety and all removed details as it should be, the return to removal. The arrow on the case of the block has to specify forward.

"previous page
11.14.4. Replacement of a back seat belt
following page"
11:15. Rear-view mirrors