Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and flaps
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box of airinflow
11.8. Cowl
11.9. Doors
11:10. Trunk lid
11:11. Cover of the hatch of a bulk pipe of the fuel tank
11:12. Seats
11:13. Removal and installation of facing of a tunnel of a floor
11:14. System of passive safety (SRS)
11:15. Rear-view mirrors
11:16. Dashboard
11:17. Heater and conditioner
11:18. Fittings of salon
11:19. Removal and installation of facings of salon
11:20. Removal and installation of facings of a luggage carrier
11:21. Screen wiper of a wind window
11:22. Replacement of a motionless glazing of a body
11:23. Removal and installation of the shelf of fastening of the rechargeable battery
11:24. Care of a body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








11-20-snyatie-i-ustanovka-oblicovok-bagazhnika.html

11:20. Removal and installation of facings of a luggage carrier

The facings of a luggage carrier formed from plastic are attached to body panels by percussion caps. The trunk floor rug from nonwoven carpet fabric is laid on a trunk floor and also attached to it by four percussion caps located in a forward part of a rug.
You will need the screw-driver with a flat edge.
1. Facing of a back left lamp is attached to a body by four percussion caps, three of which at the same time attached also a back part of facing of an arch of a back wheel. Take percussion caps …
2. … having hooked the screw-driver …
3. … also remove facing.

    
NOTE
Facing of a back right lamp is removed similarly.


4. For removal of facing of an arch of a back left wheel remove facing of a back lamp (see subitem 1-3) as three percussion caps of its fastening at the same time fixed also facing of an arch …
5. … take a percussion cap of fastening of facing of an arch to a body back partition …
6. … and two percussion caps of fastening of back facing of a sidewall which are at the same time fixing and facing of an arch.
7. Remove facing of an arch of a back left wheel.
    
NOTE
Facing of an arch of a back right wheel is removed similarly.

8. For removal of facing of the panel of a back take four percussion caps of fastening of its top part …
9. … then, having raised a back edge of a rug of a luggage carrier and a cover of a niche for a spare wheel, two percussion caps of fastening of facing to body longerons at the left and on the right …
10. … and one percussion cap of fastening of facing to a trunk floor located on the center.
11. Remove facing of the panel of a back.
12. For removal of a rug of a trunk floor take four percussion caps of its fastening located along a forward edge of a rug.
13. Establish facings of a luggage carrier and a rug of a floor as it should be, the return to removal.

"previous page
11:19. Removal and installation of facings of salon
following page"
11:21. Screen wiper of a wind window