Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and flaps
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box of airinflow
11.8. Cowl
11.9. Doors
11:10. Trunk lid
11:11. Cover of the hatch of a bulk pipe of the fuel tank
11:12. Seats
11:13. Removal and installation of facing of a tunnel of a floor
11:14. System of passive safety (SRS)
11:15. Rear-view mirrors
11:16. Dashboard
11:17. Heater and conditioner
11:18. Fittings of salon
11:19. Removal and installation of facings of salon
11:20. Removal and installation of facings of a luggage carrier
11:21. Screen wiper of a wind window
11.21.1. Replacement of brushes of a screen wiper of a wind window
11.21.2. Replacement of levers and drafts of a screen wiper of a wind window
11:22. Replacement of a motionless glazing of a body
11:23. Removal and installation of the shelf of fastening of the rechargeable battery
11:24. Care of a body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








11-21-2-zamena-rychagov-i-tyag-stekloochistitelya-vetrovogo-okna.html

11.21.2. Replacement of levers and drafts of a screen wiper of a wind window

It will be required to you: a face head "on 10", a key "on 13", the screw-driver with a flat edge.
1. Open a cowl and establish it on an emphasis.
2. Remove decorative caps from nuts of fastening of levers of a screen wiper.
3. Turn off nuts …
4. … also remove levers from axes of leads of a trapeze of a screen wiper.
5. Remove the left half of a lattice of a box of airinflow (see. "Removal and installation of a lattice of a box of airinflow").
6. From within a box of airinflow disconnect the hinge of draft of a trapeze of a screen wiper from a motor-reducer crank, having removed it from a spherical finger of a crank the screw-driver as the lever.
7. Turn off two nuts of fastening left …
8. … and right leads of a trapeze of drafts of a screen wiper …
9. … also take a trapeze from an airinflow box.

NOTE
If there were raised side plays of axes of leads 1 or hinges of drafts 2, replace leads or drafts assembled.

10. Establish details as it should be, the return to removal.

"previous page
11.21.1. Replacement of brushes of a screen wiper of a wind window
following page"
11:22. Replacement of a motionless glazing of a body