Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.3.1. Removal, dismantling and installation of a front bumper
11.3.2. Removal, dismantling and installation of a rear bumper
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and flaps
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box of airinflow
11.8. Cowl
11.9. Doors
11:10. Trunk lid
11:11. Cover of the hatch of a bulk pipe of the fuel tank
11:12. Seats
11:13. Removal and installation of facing of a tunnel of a floor
11:14. System of passive safety (SRS)
11:15. Rear-view mirrors
11:16. Dashboard
11:17. Heater and conditioner
11:18. Fittings of salon
11:19. Removal and installation of facings of salon
11:20. Removal and installation of facings of a luggage carrier
11:21. Screen wiper of a wind window
11:22. Replacement of a motionless glazing of a body
11:23. Removal and installation of the shelf of fastening of the rechargeable battery
11:24. Care of a body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








11-3-1-snyatie-razborka-i-ustanovka-perednego-bampera.html

11.3.1. Removal, dismantling and installation of a front bumper

It will be required to you: all tools necessary for removal of mudguards and flaps of forward wheels (see. "Removal and installation of mudguards of wheels and flaps"), and also a key "on 10", a face head "on 12", the screw-driver with a crosswise edge.
1. On both sides of the car remove mudguards and flaps of forward wheels (see. "Removal and installation of mudguards of wheels and flaps").
2. Open a cowl, establish it on an emphasis and turn off on one nut of the top fastening of a front bumper to a body at the left …
3. … and on the right.
4. In arches of forward wheels turn off two nuts of forward fastening of a bumper to a body …
5. … turn out on one bolt of the lower fastening …
6. … on one screw of side fastening …
7. … also remove a front bumper.
8. If necessary turn out five screws of fastening of a framework of the power absorbing element to the top edge of a bumper, four screws — to the lower edge of a bumper …
9. … remove a framework …
10. … and the power absorbing element.
11. Collect and establish a front bumper, and also all removed details as it should be, the return to removal.

"previous page
11.3. Removal, dismantling and installation of bumpers
following page"
11.3.2. Removal, dismantling and installation of a rear bumper