Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.3.1. Removal, dismantling and installation of a front bumper
11.3.2. Removal, dismantling and installation of a rear bumper
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and flaps
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box of airinflow
11.8. Cowl
11.9. Doors
11:10. Trunk lid
11:11. Cover of the hatch of a bulk pipe of the fuel tank
11:12. Seats
11:13. Removal and installation of facing of a tunnel of a floor
11:14. System of passive safety (SRS)
11:15. Rear-view mirrors
11:16. Dashboard
11:17. Heater and conditioner
11:18. Fittings of salon
11:19. Removal and installation of facings of salon
11:20. Removal and installation of facings of a luggage carrier
11:21. Screen wiper of a wind window
11:22. Replacement of a motionless glazing of a body
11:23. Removal and installation of the shelf of fastening of the rechargeable battery
11:24. Care of a body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








11-3-2-snyatie-razborka-i-ustanovka-zadnego-bampera.html

11.3.2. Removal, dismantling and installation of a rear bumper

It will be required to you: all tools necessary for removal of mudguards and flaps of back wheels (see. "Removal and installation of mudguards of wheels and flaps"), facings of back lamps and the panel of a back (see. "Removal and installation of facings of a luggage carrier"), and also a face head "on 10", the screw-driver with a crosswise edge.
1. On both sides of the car remove mudguards and flaps of back wheels (see. "Removal and installation of mudguards of wheels and flaps").
2. Open a trunk lid and remove facings of back lamps and the panel of a back (see. "Removal and installation of facings of a luggage carrier").
3. On both sides of a luggage carrier turn off nuts and turn out bolts of fastening of the ends of a bumper to a body.
4. From within both arches of back wheels turn out on one bolt of fastening of the ends of a bumper to a body.
5. Turn out four screws of fastening of a bumper to the back panel …
6. … also remove a rear bumper.
7. If necessary turn off two nuts of fastening of the side power absorbing element from within a luggage carrier …
8. … also remove the power absorbing element. Similarly remove the second side power absorbing element.
9. If necessary turn out four screws of fastening of the central power absorbing element to a rear bumper …

NOTE
Screws of fastening of the central power absorbing element are so located to a bumper.

10. … also remove the central power absorbing element.
11. Collect and establish a rear bumper, and also all removed details as it should be, the return to removal.

"previous page
11.3.1. Removal, dismantling and installation of a front bumper
following page"
11.4. Removal and installation of facing of a radiator