Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal, dismantling and installation of bumpers
11.4. Removal and installation of facing of a radiator
11.5. Removal and installation of mudguards of wheels and flaps
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice of a box of airinflow
11.8. Cowl
11.9. Doors
11.9.1. Removal and installation of an upholstery of a forward door
11.9.2. Replacement of glass of a forward door
11.9.3. Replacement of a window regulator of a forward door
11.9.4. Replacement of the external handle of a forward door
11.9.5. Replacement of the internal handle of the drive of the lock of a forward door
11.9.6. Replacement of the switch of the lock of a forward door
11.9.7. Replacement of the lock of a forward door
11.9.8. Replacement of the limiter of opening of a forward door
11.9.9. Removal and installation of a forward door
11.9.10. Removal and installation of an upholstery of a back door
11.9.11. Replacement of glass of a back door
11.9.12. Replacement of a window regulator of a back door
11.9.13. Replacement of the external handle of a back door
11.9.14. Replacement of the internal handle of the drive of the lock of a back door
11.9.15. Replacement of the lock of a back door
11.9.16. Replacement of the limiter of opening of a back door
11.9.17. Removal and installation of a back door
11:10. Trunk lid
11:11. Cover of the hatch of a bulk pipe of the fuel tank
11:12. Seats
11:13. Removal and installation of facing of a tunnel of a floor
11:14. System of passive safety (SRS)
11:15. Rear-view mirrors
11:16. Dashboard
11:17. Heater and conditioner
11:18. Fittings of salon
11:19. Removal and installation of facings of salon
11:20. Removal and installation of facings of a luggage carrier
11:21. Screen wiper of a wind window
11:22. Replacement of a motionless glazing of a body
11:23. Removal and installation of the shelf of fastening of the rechargeable battery
11:24. Care of a body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








11-9-10-snyatie-i-ustanovka-obivki-zadnejj-dveri.html

11.9.10. Removal and installation of an upholstery of a back door

It will be required to you: screw-drivers with crosswise and flat edges.
1. Having hooked the screw-driver, remove facing of the internal handle of the lock.

GOOD ADVICE
Not to scratch a detail, wrap up a screw-driver sting an insulating tape.

2. Turn out the screw of fastening of facing of a nest in a door armrest …
3. … also remove facing.
4. Wring out the window regulator handle socket to a door upholstery …
5. … through the formed gap take a spring clamp of the handle, having hooked it the screw-driver …
6. … also remove the handle of a window regulator and its socket.
7. Remove facing of a corner of a back door, overcoming effort of two of her spring holders.
8. Turn out two screws of fastening of an upholstery to the lower edge of a door.
9. Having hooked the screw-driver an upholstery in the locations of its plastic percussion caps …

    
NOTE
The upholstery (view from a reverse side) is attached to the door panel by five plastic percussion caps. Replace the damaged percussion caps new, having taken out them from upholstery arms.
If necessary remove from an upholstery a porolonovy sealing ring and the window regulator roller.


10. … disconnect an upholstery from the door panel, overcoming effort of percussion caps.
11. Turn out two screws of fastening of an arm of an armrest to the panel of a door and remove an arm.
12. Unstick a moisture protective film from the door panel.
13. Establish an upholstery of a back door and all removed details as it should be, the return to removal.

    
NOTE
At installation of an arm of an armrest of the shooter, vyshtampovanny on it, it has to be directed in the direction of the movement of the car forward.

"previous page
11.9.9. Removal and installation of a forward door
following page"
11.9.11. Replacement of glass of a back door