Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
4.1. General provisions
4.2. Daily Service (DS)
4.3. First maintenance (TO-1)
4.3.1. Check and adjustment of a tension of a belt of the drive of the generator and pump of the hydraulic booster of steering
4.3.2. Check and adjustment of a tension of a belt of the drive of the compressor of the conditioner
4.3.3. Check of a belt of the drive of the gas-distributing mechanism
4.3.4. Replacement of oil in the engine and an oil filter
4.3.5. Cleaning of system of ventilation of a case
4.3.6. Check of hoses and connections of the cooling system
4.3.7. Check of system of production of the fulfilled gases
4.3.8. Check of tightness of fuel-supply lines
4.3.9. Replacement of the fuel filter
4.3.10. Replacement of the filtering element of the air filter
4.3.11. Check and adjustment of the drive of switching off of coupling
4.3.12. Check of level and a dolivka of oil in the transmission
4.3.13. Check of protective covers of drives of forward wheels
4.3.14. Check of technical condition of details of a forward suspension bracket on the car
4.3.15. Check of technical condition of details of a back suspension bracket on the car
4.3.16. Check and adjustment of angles of installation of wheels
4.3.17. Survey and check of steering on the car
4.3.18. Check of a free wheeling (side play) of a steering wheel
4.3.19. Check of tightness of a hydraulic actuator of brakes
4.3.20. Check of degree of wear of brake shoes, disks and drums
4.3.21. Check of operation of the vacuum amplifier of brakes
4.3.22. Check of overall performance of the brake system
4.3.23. Check of the parking brake
4.3.24. Service of the rechargeable battery
4.3.25. Replacement and service of spark plugs
4.3.26. Check and adjustment of light of headlights
4.3.27. Body fittings lubricant
4.3.28. Clearing of drainage openings
4.4. Second maintenance (TO-2)
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








4-3-12-proverka-urovnya-i-dolivka-masla-v-korobku-peredach.html

4.3.12. Check of level and a dolivka of oil in the transmission

It will be required to you: a key "on 13", the syringe.

NOTES
In the transmission add BO 400075 SAE 80W oil.
Replacement of oil is not required (only a dolivka) during all service life of the transmission. However it is recommended to replace the oil which is filled in at the plant with SAE 75W-90 gearbox oil if the car a long time was operated at a temperature of air below -30 °C.

1. Turn out a stopper of the control opening of the transmission located on a transmission case near the internal hinge of the drive of the right wheel. The edge of a control opening has to have a level of oil or is slightly lower (it is possible to reach the surface of oil a finger).
2. If the level of oil is strongly lowered (it is not possible to check a finger), remove for a dolivka a protective cap from an opening stopper for filling of the oil located from above on an intermediate case of the transmission.
3. Weaken a stopper inhaling …
4. … also turn out it.

NOTE
The opening stopper for oil filling at the same time performs function of a sapun therefore check purity of openings in it.

5. Fill in oil with the syringe in an opening in an intermediate case …
6. … until its emergence from a control opening. Wrap a stopper of a control opening.

GOOD ADVICE
In a stopper the magnet for collecting metal products of wear is established, clear it before installation of a stopper.

7. Wrap an opening stopper for filling of oil and put on it a protective cap.

PREVENTION
Operation of the car without protective cap of a stopper is forbidden! At its absence road dirt will get to the transmission.

"previous page
4.3.11. Check and adjustment of the drive of switching off of coupling
following page"
4.3.13. Check of protective covers of drives of forward wheels