Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
4.1. General provisions
4.2. Daily Service (DS)
4.3. First maintenance (TO-1)
4.3.1. Check and adjustment of a tension of a belt of the drive of the generator and pump of the hydraulic booster of steering
4.3.2. Check and adjustment of a tension of a belt of the drive of the compressor of the conditioner
4.3.3. Check of a belt of the drive of the gas-distributing mechanism
4.3.4. Replacement of oil in the engine and an oil filter
4.3.5. Cleaning of system of ventilation of a case
4.3.6. Check of hoses and connections of the cooling system
4.3.7. Check of system of production of the fulfilled gases
4.3.8. Check of tightness of fuel-supply lines
4.3.9. Replacement of the fuel filter
4.3.10. Replacement of the filtering element of the air filter
4.3.11. Check and adjustment of the drive of switching off of coupling
4.3.12. Check of level and a dolivka of oil in the transmission
4.3.13. Check of protective covers of drives of forward wheels
4.3.14. Check of technical condition of details of a forward suspension bracket on the car
4.3.15. Check of technical condition of details of a back suspension bracket on the car
4.3.16. Check and adjustment of angles of installation of wheels
4.3.17. Survey and check of steering on the car
4.3.18. Check of a free wheeling (side play) of a steering wheel
4.3.19. Check of tightness of a hydraulic actuator of brakes
4.3.20. Check of degree of wear of brake shoes, disks and drums
4.3.21. Check of operation of the vacuum amplifier of brakes
4.3.22. Check of overall performance of the brake system
4.3.23. Check of the parking brake
4.3.24. Service of the rechargeable battery
4.3.25. Replacement and service of spark plugs
4.3.26. Check and adjustment of light of headlights
4.3.27. Body fittings lubricant
4.3.28. Clearing of drainage openings
4.4. Second maintenance (TO-2)
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








4-3-26-proverka-i-regulirovka-sveta-far.html

4.3.26. Check and adjustment of light of headlights

You carry out check and adjustment of light of headlights on the equipped car (with completely filled fuel tank, a set of tools and a spare wheel).
You will need the screw-driver with a crosswise edge.
1. Previously check and if necessary bring to norm air pressure in tires.

Регулировка света фар
Fig. 4.6. Adjustment of light of headlights

2. Install the car perpendicular to a smooth wall (for example, in a garage) at distance of 3 m. Put additional freight weighing 75 kg on the driver's seat. Mark on a wall the screen, as shown in fig. 4.6. The longitudinal plane of symmetry of the car has to pass across the line 0 on the screen. Rock the car sideways that springs of suspension brackets samoustanovitsya.
3. Measure on your car height of the centers of headlights from a floor. It will be h distance on the screen.
4. Install the regulator of the electroproofreader of light of headlights on dashboards in the situation corresponding to car loading with one driver.
5. Turn on passing beam.
6. The direction of a light spot is recommended to be regulated for each headlight separately. During adjustment close the second headlight opaque material.
7. Open a cowl and, rotating adjusting screws, adjust situation on the screen of a light spot for each headlight across …
8. … and down, if the arrangement of light spots does not correspond to the drawing.
9. Headlights are considered adjusted when the upper bounds of the left parts of light spots coincide with the line 4 (see fig. 4.6), and vertical lines 1 and 2 pass through points of E1 and E2 of crossing of horizontal and inclined sites of light spots.
If on the car fog lights are established, then the direction of their beam of light needs to be adjusted only on height. Rotating the adjusting screw, achieve that the upper bounds of light spots were on the line 4 or slightly below it.

"previous page
4.3.25. Replacement and service of spark plugs
following page"
4.3.27. Body fittings lubricant