Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
5.1. Features of a design
5.2. Check of a compression in cylinders
5.3. Removal and installation of mudguards of the engine
5.4. Replacement of support of a suspension bracket of the power unit
5.5. Installation of the piston of the first cylinder in the provision of VMT of a step of compression
5.6. Removal, installation and troubleshooting of a flywheel
5.7. Replacement of details of consolidation of the engine
5.8. Head of the block of cylinders
5.9. Removal and installation of the engine
5.10. Repair of the engine
5.11. Lubrication system
5.12. Cooling system
5.13. System of production of the fulfilled gases
5.13.1. Features of a design
5.13.2. Replacement of pillows of a suspension bracket of system of production of the fulfilled gases
5.13.3. Replacement of the main muffler
5.13.4. Replacement of the additional muffler
5.13.5. Replacement of converter of the fulfilled gases or a pro-rate
5.13.6. Replacement of a reception pipe
5.13.7. Removal and installation of thermoscreens
5.14. Engine power supply system
5.15. System of catching of vapors of fuel
5.16. System of recirculation of the fulfilled gases
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








5-13-5-zamena-nejjtralizatora-otrabotavshikh-gazov-ili-prostavki.html

5.13.5. Replacement of converter of the fulfilled gases or a pro-rate

1. Turn off three nuts of fastening of a flange of a pipe of the additional muffler to a converter flange (or pro-rates), disconnect the additional muffler from converter and remove sealing laying (see subitems 2 and 4 of the subsection "Replacement of the Additional Muffler").
2. Turn off three nuts of fastening of a flange of a reception pipe to a flange of converter of the fulfilled gases (or to a pro-rate flange)...
3. … also remove converter (pro-rate).
4. Remove sealing laying from flanges of converter (pro-rate).

GOOD ADVICE
Replace sealing laying between flanges of converter (pro-rate), a pipe of the additional muffler and a reception pipe at each dismantling of connection new.

5. Establish new converter (pro-rate) as it should be, the return to removal.

"previous page
5.13.4. Replacement of the additional muffler
following page"
5.13.6. Replacement of a reception pipe