Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
5.1. Features of a design
5.2. Check of a compression in cylinders
5.3. Removal and installation of mudguards of the engine
5.4. Replacement of support of a suspension bracket of the power unit
5.5. Installation of the piston of the first cylinder in the provision of VMT of a step of compression
5.6. Removal, installation and troubleshooting of a flywheel
5.7. Replacement of details of consolidation of the engine
5.8. Head of the block of cylinders
5.9. Removal and installation of the engine
5.10. Repair of the engine
5.11. Lubrication system
5.12. Cooling system
5.13. System of production of the fulfilled gases
5.14. Engine power supply system
5.15. System of catching of vapors of fuel
5.16. System of recirculation of the fulfilled gases
5.16.1. Features of the device
5.16.2. Removal, check and installation of the pneumatic valve of recirculation of the fulfilled gases
5.16.3. Removal, check and installation of the electromagnetic valve of system of recirculation of the fulfilled gases
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








5-16-2-snyatie-proverka-i-ustanovka-pnevmaticheskogo-klapana-recirkulyacii-otrabotavshikh-gazov.html

5.16.2. Removal, check and installation of the pneumatic valve of recirculation of the fulfilled gases

You will need a key "on 12".
1. Disconnect a vacuum hose from the pneumatic valve of recirculation of the fulfilled gases.
2. Turn out two bolts of fastening of the valve to an inlet pipe …
3. … also remove the valve.
    
NOTE
Connection of the valve with an inlet pipe is condensed with laying. At each dismantling of connection replace sealing laying new.

4. For valve check give in any way depression to its vacuum chamber and watch movement of a plunger (it is shown by an arrow). If the plunger remains motionless, replace the valve.
5. Install the pneumatic valve of recirculation of the fulfilled gases as it should be, the return to removal.

"previous page
5.16.1. Features of the device
following page"
5.16.3. Removal, check and installation of the electromagnetic valve of system of recirculation of the fulfilled gases