Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
5.1. Features of a design
5.2. Check of a compression in cylinders
5.3. Removal and installation of mudguards of the engine
5.4. Replacement of support of a suspension bracket of the power unit
5.5. Installation of the piston of the first cylinder in the provision of VMT of a step of compression
5.6. Removal, installation and troubleshooting of a flywheel
5.7. Replacement of details of consolidation of the engine
5.8. Head of the block of cylinders
5.9. Removal and installation of the engine
5.10. Repair of the engine
5.11. Lubrication system
5.12. Cooling system
5.13. System of production of the fulfilled gases
5.14. Engine power supply system
5.15. System of catching of vapors of fuel
5.16. System of recirculation of the fulfilled gases
5.16.1. Features of the device
5.16.2. Removal, check and installation of the pneumatic valve of recirculation of the fulfilled gases
5.16.3. Removal, check and installation of the electromagnetic valve of system of recirculation of the fulfilled gases
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








5-16-3-snyatie-proverka-i-ustanovka-ehlektromagnitnogo-klapana-sistemy-recirkulyacii-otrabotavshikh-gazov.html

5.16.3. Removal, check and installation of the electromagnetic valve of system of recirculation of the fulfilled gases

1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Disconnect a block of a plait of wires from the electromagnetic valve.
3. Disconnect hoses of a supply and withdrawal of depression from valve unions.
4. Wring out a clamp of fastening of the electromagnetic valve to an arm of an inlet pipe …
5. … also remove the valve.
    
NOTE
Pay attention to marking on the valve case that when replacing to install the same valve.

6. For valve check attach the medical syringe to the taking-away valve union (it is used as the pump). Press a syringe plunger — in the valve pressure has to be created (it can be felt on the aspiration of a plunger of the syringe to return to a starting position). Then connect a source of a direct current of 12 V to valve conclusions — the valve has to open, and pressure has to disappear (the syringe plunger without resistance will move against the stop). Otherwise replace the valve.
7. Install the valve as it should be, the return to removal.

"previous page
5.16.2. Removal, check and installation of the pneumatic valve of recirculation of the fulfilled gases
following page"
6. Transmission