Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
6.1. Coupling
6.1.1. Features of a design
6.1.2. Removal and installation of coupling
6.1.3. Replacement of a fork and bearing of switching off of coupling
6.1.4. Replacement of the main cylinder of the drive of switching off of coupling
6.1.5. Replacement of the working cylinder of the drive of switching off of coupling
6.1.6. Replacement of a hose and tube of a hydraulic actuator of switching off of coupling
6.1.7. Removal and installation of a pedal of coupling
6.1.8. Pumping of a hydraulic actuator of switching off of coupling
6.2. Transmission
6.3. Drives of forward wheels
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








6-1-2-snyatie-i-ustanovka-scepleniya.html

6.1.2. Removal and installation of coupling

It will be required to you: a key "on 11", a mandrel for centering of the conducted disk.
1. Remove the transmission (see. "Removal and installation of the transmission").
2. Holding a flywheel the screw-driver from a provorachivaniye, turn out six bolts of fastening of a casing of a press clutch plate to a flywheel. Weaken an inhaling of bolts evenly: on one turn of a key everyone, passing from a bolt to a bolt on diameter.

    
NOTE
For descriptive reasons work is shown on the removed engine.

3. Remove a casing and the conducted clutch plate.



Оправка для центрирования ведомого диска сцепления
Fig. 6.2. A mandrel for centering of the conducted clutch plate
    
NOTE
For centering of coupling make a mandrel according to fig. 6.2.

4. At coupling installation at first establish by means of a mandrel (see fig. 6.2) the conducted disk, then a casing of a press disk and screw bolts of fastening of a casing to a flywheel. Roll bolts evenly: on one turn of a key everyone, passing from a bolt to a bolt on diameter. Moment of an inhaling of bolts of 15 N · m.
5. Remove a mandrel and install the transmission.
6. Check and if necessary adjust the coupling switching off drive (see. "Check and adjustment of the drive of switching off of coupling").

"previous page
6.1.1. Features of a design
following page"
6.1.3. Replacement of a fork and bearing of switching off of coupling