Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
6.1. Coupling
6.2. Transmission
6.2.1. Features of a design
6.2.2. Possible malfunctions of the transmission, their reason and ways of elimination
6.2.3. Replacement of oil in the transmission
6.2.4. Replacement of epiploons of the transmission
6.2.5. Removal and installation of the transmission
6.2.6. Dismantling and assembly of the transmission and troubleshooting of its details
6.2.7. Repair of a secondary shaft
6.2.8. Repair of a main shaft
6.2.9. Repair of the synchronizer
6.2.10. Repair of differential
6.2.11. Repair of the mechanism of gear shifting
6.2.12. Repair of hinges of the drive of gear shifting
6.2.13. Removal, installation and repair of the coulisse of a control lever transmission
6.2.14. Adjustment of the drive of control of the transmission
6.3. Drives of forward wheels
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








6-2-13-snyatie-ustanovka-i-remont-kulisy-rychaga-upravleniya-korobkojj-peredach.html

6.2.13. Removal, installation and repair of the coulisse of a control lever transmission

If after repair or replacement of the drive of gear shifting vibration of the lever of gear shifting at the movement remains, so there is a raised side play in hinges of the lever and they need to be repaired.
It will be required to you: keys "on 12", "on 14", a face key "on 10", the screw-driver.
1. In a motor compartment weaken a nut of a bolt of klemmovy connection of a tip of the lever and draft of gear shifting.
2. Remove the coupling coupling from draft …
3. … and protective cover.
4. In salon take from a forward part of facing of a tunnel of a floor a control lever cover frame the transmission, overcoming effort of its clamps.
5. Turn a lever cover inside out, have a bite bokorezam (or knife) a collar of fastening of a cover and remove a cover from the lever.

    
NOTE
Collar of fastening of a cover of the lever of gear shifting of one-time use. At assembly establish a new collar.

6. Remove a forward part of facing of a tunnel of a floor (see. "Removal and installation of facing of a tunnel of a floor").
7. Unfasten an axis clamp from the lever …
8. … also remove a lever axis, taking it from openings of the lever and the coulisse.
9. Having pulled up, remove the gear shifting lever.
10. Push the screw-driver in the lever case the rezinoplastmassovy directing plug and advance it lengthways on a shaft.
11. Turn out four bolts of fastening of the case of the lever to the body basis.
12. Remove the case and take from it a shaft.
13. Remove the directing plug from a shaft.
14. Examine the removed details. If the opening of the directing plug is worn out or its rubber massif is deformed or hardened, replace the plug assembled. If in hinges of the coulisse there is a side play or the opening under a lever axis is worn strongly out, replace the coulisse.
15. Establish details in the sequence, the return to removal.
16. Adjust the gear shifting drive (see. "Adjustment of the drive of control of the transmission").

"previous page
6.2.12. Repair of hinges of the drive of gear shifting
following page"
6.2.14. Adjustment of the drive of control of the transmission