Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.1.1. Features of a design
7.1.2. Possible malfunctions of a forward suspension bracket, their reason and ways of elimination
7.1.3. Removal and installation of a damping rack
7.1.4. Repair of a damping rack
7.1.5. Replacement of the top support of a damping rack
7.1.6. Replacement of a spherical support of a damping rack
7.1.7. Replacement of the lever of a forward suspension bracket
7.1.8. Replacement of details of the stabilizer of cross stability of a forward suspension bracket
7.1.9. Replacement of the bearing of a forward nave
7.2. Back suspension bracket
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








7-1-6-zamena-sharovojj-opory-amortizatornojj-stojjki.html

7.1.6. Replacement of a spherical support of a damping rack

If check of a support confirmed need of its replacement (see. "Check of technical condition of a forward suspension bracket on the car"), replace it.
It will be required to you: keys "on 17" (two), "on 19", a key for bolts of wheels, a stripper of spherical hinges, a drill, a drill on metal with a diameter of 12 mm.
1. Lift and establish a forward part of the car on support. Remove a wheel.

    
PREVENTIONS
Slow down the car the parking brake and establish an antiretractable emphasis ("boots") under back wheels.
Weaken and tighten bolts of fastening of a wheel only on the car standing on the earth.

2. Remove a spring clamp of a nut of a finger of a spherical support.
3. Turn off a nut of fastening of a finger of a spherical support to the suspension bracket lever...
4. … establish a stripper of spherical hinges and a vypressuyta a finger from the lever.
5. If the spherical support is attached to the lever by rivets (factory installation), drill three rivets.
    
GOOD ADVICE
It is more convenient to drill rivets on the removed lever of a forward suspension bracket (see. "Replacement of the lever of a forward suspension bracket").

6. If the support is attached by bolts (it already changed), turn off three самоконтрящиеся nuts, holding bolts from a provorachivaniye the second key.
    
PREVENTION
Самоконтрящиеся nuts are not subject to reuse, replace them new.

7. Take rivets (bolts) from openings of a spherical support and the lever, then remove a support.
8. Establish a spherical support as it should be, the return to removal.
    
PREVENTION
At installation do not damage a protective cover of a spherical support.

9. Having lowered the car on the earth, several times strongly rock it. Tighten a nut of fastening of a finger of a spherical support and bolts of fastening of a support to the lever the moment of 70 N · m, establish a spring clamp of a nut of a finger of a support.

NOTE
After replacement of a spherical support of a forward suspension bracket check and if necessary adjust the angles of installation of wheels. Use services of the workshops having the special equipment.

"previous page
7.1.5. Replacement of the top support of a damping rack
following page"
7.1.7. Replacement of the lever of a forward suspension bracket