Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
7.1. Forward suspension bracket
7.1.1. Features of a design
7.1.2. Possible malfunctions of a forward suspension bracket, their reason and ways of elimination
7.1.3. Removal and installation of a damping rack
7.1.4. Repair of a damping rack
7.1.5. Replacement of the top support of a damping rack
7.1.6. Replacement of a spherical support of a damping rack
7.1.7. Replacement of the lever of a forward suspension bracket
7.1.8. Replacement of details of the stabilizer of cross stability of a forward suspension bracket
7.1.9. Replacement of the bearing of a forward nave
7.2. Back suspension bracket
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








7-1-7-zamena-rychaga-perednejj-podveski.html

7.1.7. Replacement of the lever of a forward suspension bracket

It will be required to you: keys "on 12", "on 14", "on 17", "on 19", "on 22", a face head "on 12", kruglogubets, a stripper of spherical hinges.
1. Slow down the car the parking brake and establish an antiretractable emphasis ("boots") under back wheels. Raise a jack a forward part of the car and establish it on support. Remove a wheel.
    
PREVENTION
Weaken and tighten bolts of fastening of a wheel only on the car standing on the earth.

2. Remove a spring clamp, turn off a nut of fastening of a finger of a spherical support and a vypressuyta a finger (see. "Replacement of a spherical support of a damping rack").
3. Turn off a nut of fastening of a rack of the stabilizer to a bar and remove a rack (see. "Replacement of details of the stabilizer of cross stability of a forward suspension bracket").
4. Turn out two bolts of fastening of a bracket of a back support of the lever …
5. … also remove a bracket.
6. Turn off a nut of fastening of a bolt of a forward support of the lever...
7. … remove a washer, take out a bolt together with the second washer...
    
GOOD ADVICE
If the bolt is not taken out, beat out it from a body arm, striking blows to a back part of the lever.

8. … also remove the lever assembled with a spherical support.
    
NOTE
As original lower levers of a forward suspension bracket deliver in the spare part assembled with a spherical support, saylentbloky and the plug of a back support, further dismantling of the lever does not make sense. It is only possible to remove the plug of a back support delivered separately in the spare part which is easy for bringing down from an axis blows of the hammer.

9. Establish details as it should be, the return to removal, without delaying finally fastening of rubber-metal hinges of the lever and the stabilizer of cross stability.
10. Having lowered the car on the earth, several times strongly rock it. Finally tighten threaded connections of a suspension bracket on the car standing on the earth, the moment specified in the appendix 1.

NOTE
After replacement of a spherical support of a forward suspension bracket check and if necessary adjust the angles of installation of wheels. Use services of the workshops having the special equipment.

"previous page
7.1.6. Replacement of a spherical support of a damping rack
following page"
7.1.8. Replacement of details of the stabilizer of cross stability of a forward suspension bracket