Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
8.1. Features of a design
8.2. Steering column
8.2.1. Removal and installation of a steering wheel
8.2.2. Removal and installation of a steering column
8.2.3. Replacement of the bearing of a steering column
8.3. Steering drafts
8.4. Steering mechanism
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








8-2-1-snyatie-i-ustanovka-rulevogo-kolesa.html

8.2.1. Removal and installation of a steering wheel

You will need a face head "on 22".
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Establish a steering wheel in the situation corresponding to the rectilinear movement of the car.
3. Remove the module of a safety cushion of the driver (see. "Removal and installation of a safety cushion of the driver").
4. Weaken an inhaling of a nut of fastening of a steering wheel to a steering shaft, holding a steering wheel from a provorachivaniye.

PREVENTION
Completely do not turn off a nut of fastening of a wheel, otherwise at removal it is possible to put with hands of a steering wheel to itself a trauma in case of its sharp detachment from a steering shaft as the steering wheel is sprung.
    
GOOD ADVICE
It is possible to record a steering wheel from a provorachivaniye by means of the locking mechanism of the anti-theft device of the lock of ignition. For this purpose take out a key from the lock of ignition and turn a steering wheel until fixing of a shaft the anti-theft device. After weakening of an inhaling of a nut of fastening of a steering wheel switch-off the anti-theft device, having inserted a key into the ignition lock, and again establish a steering wheel in provision of the rectilinear movement.

5. Sharp blows of hands bring down a steering wheel from shliyets of a steering shaft …
6. … finally turn off a fastening nut …
7. … also remove a steering wheel.
8. Record a contact ring of a safety cushion from a provorachivaniye a pin of suitable diameter.
9. Remove the spring established under a steering wheel.
10. Establish a steering wheel as it should be, the return to removal.

"previous page
8.2. Steering column
following page"
8.2.2. Removal and installation of a steering column