Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
8.1. Features of a design
8.2. Steering column
8.2.1. Removal and installation of a steering wheel
8.2.2. Removal and installation of a steering column
8.2.3. Replacement of the bearing of a steering column
8.3. Steering drafts
8.4. Steering mechanism
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








8-2-2-snyatie-i-ustanovka-rulevojj-kolonki.html

8.2.2. Removal and installation of a steering column

It will be required to you: a key "on 12", a face head "on 12" with the extender.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove a steering wheel (see. "Removal and installation of a steering wheel"), previously having established it in the situation corresponding to the rectilinear movement.
3. Remove understeering switches assembled with a connector (see. "Replacement of understeering switches").
4. Under the dashboard turn off a nut and take a bolt of klemmovy connection of a steering shaft and the elastic coupling.
5. Turn off a nut of the lower fastening of a steering column.
6. Turn off two nuts of fastening of a steering column to the dashboard.
7. Take a shaft of a steering shaft from the plug of the rubber coupling and remove a steering column from the car.
8. Take a steering shaft from the column case …
9. … also remove the plastic aligning plug.
10. Install the aligning plug on a steering shaft, and a shaft – in the case of a steering column.
11. Insert a shaft of a steering shaft into the rubber coupling.
12. Shift the aligning plug so that it entered the case of a steering column.
13. Tighten a nut of a coupling bolt of klemmovy connection of a steering shaft and the elastic coupling.
14. Tighten a nut of lower …
15. … and two nuts top fastenings of a steering column.
16. Shift the aligning plug on a steering shaft so that it went out of the case of a steering column.
17. Further establish details as it should be, the return to removal.

"previous page
8.2.1. Removal and installation of a steering wheel
following page"
8.2.3. Replacement of the bearing of a steering column