Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of the brake system, their reason and ways of elimination
9.3. Pumping of a hydraulic actuator of the brake system
9.4. Check and adjustment of provision of a pedal of a brake
9.5. Main brake cylinder
9.6. Vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydraulic actuator of brakes
9.8. Removal and installation of a pedal of a brake
9.9. Brake mechanisms of forward wheels
9.10. Brake mechanisms of back wheels
9.11. Parking brake
9.11.1. Adjustment of the drive of the parking brake
9.11.2. Replacement of a forward cable of the drive of the parking brake
9.11.3. Replacement of a back cable of the drive of the parking brake
9.11.4. Removal and installation of the lever of the drive of the parking brake
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








9-11-4-snyatie-i-ustanovka-rychaga-privoda-stoyanochnogo-tormoza.html

9.11.4. Removal and installation of the lever of the drive of the parking brake

Assembled remove the lever for replacement at wear or damage of the gear sector or a doggie.
It will be required to you: a key "on 12", the screw-driver with a crosswise edge.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Remove a back part of facing of a tunnel of a floor (see. "Removal and installation of facing of a tunnel of a floor").

NOTE
The seat of the driver is removed for descriptive reasons. To get access to fastenings of facing and the lever of the parking brake, it is not required to remove a seat.

3. Disconnect a wire block from the switch of an alarm lamp of turning on of the parking brake.
4. Disconnect a forward cable of the drive from the lever of the drive of the parking brake (see. "Replacement of a forward cable of the drive of the parking brake").
5. Turn out two bolts of fastening of the lever of the drive of the parking brake to the body basis …
6. … also remove the lever.
7. Before installation on the car grease with jellied lubricant the gear sector of the lever.
8. Install the lever as it should be, the return to removal, and adjust the parking brake system (see. "Adjustment of the drive of the parking brake").

"previous page
9.11.3. Replacement of a back cable of the drive of the parking brake
following page"
10. Electric equipment