Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of the brake system, their reason and ways of elimination
9.3. Pumping of a hydraulic actuator of the brake system
9.4. Check and adjustment of provision of a pedal of a brake
9.5. Main brake cylinder
9.5.1. Replacement of a tank of the main brake cylinder
9.5.2. Replacement of the main brake cylinder
9.5.3. Replacement of regulators of brake forces
9.6. Vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydraulic actuator of brakes
9.8. Removal and installation of a pedal of a brake
9.9. Brake mechanisms of forward wheels
9.10. Brake mechanisms of back wheels
9.11. Parking brake
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








9-5-1-zamena-bachka-glavnogo-tormoznogo-cilindra.html

9.5.1. Replacement of a tank of the main brake cylinder

You will need the screw-driver.
1. Disconnect a wire from the minus plug of the rechargeable battery.
2. Having unclenched clamps, disconnect a block of a plait of wires from a stopper of a tank of the main brake cylinder.
3. Turn off a stopper of a tank of the main brake cylinder.
4. Pump out brake fluid from a tank, for example, the big medical syringe.
5. Weaken a collar of fastening of a hose to the main cylinder of switching off of coupling, shift a collar on a hose …
6. … also disconnect a hose from a tank of the main brake cylinder.

    
GOOD ADVICE
At once after a hose detachment from a tank muffle its opening, without lowering a hose down. At the same time in a hose there will be a quantity of working liquid therefore after installation of a tank and accession of a hose to it it will not be required to delete air from a coupling switching off hydraulic actuator.

7. Having hooked the screw-driver, remove a tank, taking its branch pipes from connecting plugs.
8. If leak of brake fluid via connecting plugs was in use observed, take plugs from cylinder case openings.
    
PREVENTION
Reuse of connecting plugs is not allowed, replace them new.

9. Before installation of a tank insert connecting plugs into openings of the main brake cylinder. Then install a tank, having inserted its branch pipes into connecting plugs by effort of a hand against the stop.

GOOD ADVICE
For simplification of installation of connecting plugs in the cylinder and tank branch pipes in plugs moisten them with fresh brake fluid.

10. Fill in brake fluid and remove air from a hydraulic actuator (see. "Pumping of a hydraulic actuator of the brake system").

"previous page
9.5. Main brake cylinder
following page"
9.5.2. Replacement of the main brake cylinder