Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of the brake system, their reason and ways of elimination
9.3. Pumping of a hydraulic actuator of the brake system
9.4. Check and adjustment of provision of a pedal of a brake
9.5. Main brake cylinder
9.6. Vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydraulic actuator of brakes
9.8. Removal and installation of a pedal of a brake
9.9. Brake mechanisms of forward wheels
9.9.1. Replacement of brake shoes of the brake mechanism of a forward wheel
9.9.2. Replacement of a support of the forward brake mechanism
9.9.3. Replacement of a brake disk
9.10. Brake mechanisms of back wheels
9.11. Parking brake
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








9-9-2-zamena-supporta-perednego-tormoznogo-mekhanizma.html

9.9.2. Replacement of a support of the forward brake mechanism

It will be required to you: a key "on 12", a key hexagon "on 10", a key for bolts of wheels, capacity for discharge of brake fluid.
1. Remove a wheel.
2. Turn out a bolt union and disconnect a brake hose from a support (see. "Replacement of brake hoses").

    
GOOD ADVICE
Substitute capacity for discharge of the rest of brake fluid from a hose and the cylinder.

3. Turn out two bolts of fastening of a guide of blocks to a rotary fist …
4. … also remove a support assembled.
5. Establish a support as it should be, the return to removal. Before installation of bolts of fastening of a support to a rotary fist apply an anaerobic clamp of a carving on a carving. At installation of a brake hose use only new copper washers. After installation restore the level of brake fluid in a tank of the main brake cylinder and remove air from a hydraulic actuator of brakes (see. "Pumping of a hydraulic actuator of the brake system").

"previous page
9.9.1. Replacement of brake shoes of the brake mechanism of a forward wheel
following page"
9.9.3. Replacement of a brake disk