Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
4.1. General provisions
4.2. Daily Service (DS)
4.2.1. Check of wheels
4.2.2. Check of level and a dolivka of oil in the lubrication system
4.2.3. Check of level and dolivka of cooling liquid
4.2.4. Check of level and a dolivka of brake fluid in a tank of a hydraulic actuator of the brake system
4.2.5. Check of level and a dolivka of working liquid in a tank of the hydraulic booster of steering
4.2.6. Check of level and dolivka of windshield washer fluid
4.2.7. Check of external lighting fixtures
4.3. First maintenance (TO-1)
4.4. Second maintenance (TO-2)
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








4-2-1-proverka-koles.html

4.2.1. Check of wheels

It will be required to you: manometer, pump, caliper.

USEFUL TIPS
Periodically check air pressure in tires (tab. 4.2). The increased or lowered pressure results in premature wear of tires, deterioration in controllability and stability of the car.
We recommend to use the foot pump with the built-in manometer.


Fig. 4.1. Scheme of shift of wheels

In order that tires wore out evenly, through each 10 000 km of a run rearrange wheels according to the scheme in fig. 4.1.
Besides, through each 10 000 km of a run balance wheels and check the angles of installation of forward wheels. For this purpose address in a specialized workshop.

The table 4.2 Air Pressure in tires *, kPa
* Pressure in cold tires is specified. If there is no opportunity to measure pressure in cold tires, it is necessary to add to the values of 20-30 kPa specified in the table.

    
NOTE
Air pressure in tires is specified on a sticker from the inside of a cover of a ware box.

    
PREVENTIONS
You carry out all works on repair of wheels in specialized workshops.
Check that after repair the wheel was balanced.
Operation of tires with a worn-out protector can lead to accident.

1. Turn off a cap from the gate.
2. Check air pressure in the tire. For this purpose drop indications of the manometer on zero, having pressed the special button on the manometer case, connect the manometer to the gate and press a gate zolotnik a manometer tip.
3. If pressure is less than demanded, connect a hose tip to the gate and pump up air, controlling pressure on the manometer.
4. If pressure is more than demanded, press a special ledge of the manometer on a tip of a zolotnik and let out the air from the tire. Measure the manometer pressure. Repeating these operations, bring pressure to norm.
5. If you noticed that air pressure in tires constantly falls, try to wrap more tightly a zolotnik by means of a cap with a key.

    
NOTE
So the protective cap with a key for a zolotnik inhaling looks.

    
PREVENTION
In order to avoid pollution of zolotniks do not operate the car without protective caps. If caps were lost, surely establish new.

6. To check tightness of a zolotnik, wet a gate opening.
7. If there were vials of the coming-out air, replace a zolotnik, having turned out faulty by means of a cap with a key.
8. Measure by a caliper the residual depth of a protector. If depth of a protector of 1,6 mm or is less, replace the tire.
9. If near at hand there is no caliper, then depth of a protector can be checked visually on indicators of wear of the tire in the form of continuous cross strips on a protector.

    
NOTE
The locations of indicators are marked on a tire sidewall with a triangle or the letters "TWI".

10. Take off a decorative cap …
11. … also check an inhaling of bolts of fastening of wheels. Moment of an inhaling of bolts of fastening of a wheel of 90 N · m.

"previous page
4.2. Daily Service (DS)
following page"
4.2.2. Check of level and a dolivka of oil in the lubrication system