Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
6.1. Coupling
6.2. Transmission
6.3. Drives of forward wheels
6.3.1. Features of a design
6.3.2. Possible malfunctions of drives of forward wheels, their reasons and ways of elimination
6.3.3. Removal and installation of drives of forward wheels
6.3.4. Replacement of hinges of equal angular speeds
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








6-3-3-snyatie-i-ustanovka-privodov-perednikh-koles.html

6.3.3. Removal and installation of drives of forward wheels

Drives of forward wheels are removed for their replacement at damage or for replacement of hinges. Besides, drives of forward wheels should be removed for receiving access to other units.
It will be required to you: a key "on 19", a face head "on 32", a dynamometer key, a key for bolts of wheels, the screw-driver with a flat edge, a stripper of spherical hinges, an assembly shovel.
1. Weaken an inhaling of a nut of a nave of a forward wheel.
2. Weaken an inhaling of bolts of fastening of a wheel, then lift a forward part of the car and establish on reliable support.
3. Remove a wheel, turn off a nave nut …
4. … also remove a persistent washer, having hooked the screw-driver.
5. Remove a spring clamp of a nut of a finger of a spherical support, turn off a nut and a vypressuyta a finger a stripper (see. "Replacement of a spherical support of a damping rack").
6. Take a telescopic rack aside a little and take a shaft of the external hinge of equal angular speeds from a nave.

    
GOOD ADVICE
If it is not possible to take a hinge shaft by effort of hands, beat out it from a nave easy blows of the hammer through a wooden pro-rate.

    
NOTE
At removal of the drive the effluence of a part of oil from the transmission therefore prepare capacity for collecting oil is possible.

7. Having rested an assembly shovel against a transmission case through a wooden pro-rate, a vypressuyta the internal hinge of the drive from a semi-axial gear wheel …
8. … also remove the drive of a forward wheel assembled.
    
PREVENTION
Replace a lock ring of a shaft of the internal hinge with a new ring at each removal of the drive from the car.

9. Install the drive and the removed details as it should be, the return to removal. Finally tighten a nave nut on the car standing on the earth, the moment specified in the appendix 1.
10. After an inhaling stop a nut with small beards and the hammer.
11. The second drive is replaced similarly.
12. After installation of all details check oil level in the transmission and if necessary add (see. "Check of level and dolivka of oil in the transmission".

"previous page
6.3.2. Possible malfunctions of drives of forward wheels, their reasons and ways of elimination
following page"
6.3.4. Replacement of hinges of equal angular speeds