Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of the brake system, their reason and ways of elimination
9.3. Pumping of a hydraulic actuator of the brake system
9.4. Check and adjustment of provision of a pedal of a brake
9.5. Main brake cylinder
9.6. Vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydraulic actuator of brakes
9.8. Removal and installation of a pedal of a brake
9.9. Brake mechanisms of forward wheels
9.10. Brake mechanisms of back wheels
9.11. Parking brake
9.11.1. Adjustment of the drive of the parking brake
9.11.2. Replacement of a forward cable of the drive of the parking brake
9.11.3. Replacement of a back cable of the drive of the parking brake
9.11.4. Removal and installation of the lever of the drive of the parking brake
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








9-11-3-zamena-zadnego-trosa-privoda-stoyanochnogo-tormoza.html

9.11.3. Replacement of a back cable of the drive of the parking brake

Replace a back cable of the drive of the parking brake at its excessive pulling (impossibility of adjustment of the parking brake), mechanical injuries of veins of a cable or its cover.
    
NOTE
Each brake mechanism of back wheels is given by a separate cable. Removal and installation of the left cable are shown. The right cable is removed and established similarly.

It will be required to you: a key and a face head "on 10", the screw-driver with a flat edge, passatizh.
1. Weaken a tension of cables of the drive, having turned off an adjusting nut till the end of a carving tip of a forward cable (see subitems 1 and 2 "Replacement of a forward cable of the drive of the parking brake"), but without removing a nut absolutely.
2. Disconnect a tip of a back cable of the drive from the equalizer, having brought him out of an equalizer cut.
3. Having turned off fastening nuts, remove the supporting cable arm on a guard of the fuel tank …
4. … then forward …
5. … and back holders on a body …
6. … and also the holder on the lever of a back suspension bracket.
7. Having hooked the screw-driver, take the adjusting plug of a cover of a cable from an arm on the basis of a body …
8. … also take out a cable from an arm opening.
9. Remove the brake drum (see. "Removal and installation of the brake drum").
10. Wring out the screw-driver razzhimny the lever forward …
11. … and passatizham disconnect a cable tip from the razzhimny lever.
12. Remove a spring clamp of a cover of a cable from a reverse side of a board of a brake …
13. … and, having extended a cable through an opening in a board, remove it from the car.
14. Establish a back cable of the drive of the parking brake as it should be, the return to removal.
15. Adjust the parking brake system (see. "Adjustment of the drive of the parking brake").

"previous page
9.11.2. Replacement of a forward cable of the drive of the parking brake
following page"
9.11.4. Removal and installation of the lever of the drive of the parking brake