Chevrolet Lanos (since 2004 release)
1. Car device
2. Recommendations about operation
3. Malfunctions in way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
9.1. Features of a design
9.2. Possible malfunctions of the brake system, their reason and ways of elimination
9.3. Pumping of a hydraulic actuator of the brake system
9.4. Check and adjustment of provision of a pedal of a brake
9.5. Main brake cylinder
9.6. Vacuum amplifier of brakes
9.7. Replacement of hoses and tubes of a hydraulic actuator of brakes
9.8. Removal and installation of a pedal of a brake
9.9. Brake mechanisms of forward wheels
9.10. Brake mechanisms of back wheels
9.11. Parking brake
10. Electric equipment
11. Body
12. Wheels and tires
13. Purchase of spare parts
14. A trip on HUNDRED
15. Winter operation of the car
16. Preparation for checkup
17. Advice to the beginning mechanic
18. Appendices
19. Schemes of electric equipment
 








9-8-snyatie-i-ustanovka-pedali-tormoza.html

9.8. Removal and installation of a pedal of a brake

The pedal of a brake is removed for replacement of plastic plugs of its axis and the plug of a finger of a fork of a pusher of the vacuum amplifier of brakes at emergence of a scratch, jamming or the increased side play, and also for replacement of a returnable spring at its damage.
It will be required to you: keys "on 14", "on 15", passatizh, the screw-driver.
1. In salon under the dashboard disconnect the stoplight switch from a brake pedal arm (see. "Replacement of sensors and switches").
2. Disconnect a pusher of the vacuum amplifier of brakes from a brake pedal. For this purpose passatizham remove a lock washer of a finger of a fork of a pusher …
3. … also take a finger from openings of a fork and a pedal.
4. Take an axis of a pedal of a brake the same as it was done at removal of a pedal of coupling (see subitems 3 and 4 "Removal and installation of a pedal of coupling"), and remove a pedal.
5. If necessary remove a returnable spring, having brought its unbent ends out of arm openings.
6. Remove from a pedal the plug of 1 finger and two plugs 2 axes.
7. Establish a pedal of a brake and all removed details as it should be, the return to removal.

"previous page
9.7.2. Replacement of brake tubes
following page"
9.9. Brake mechanisms of forward wheels